Hi all
Have been searching for answer before I posted, have kind of found an answer but need some clarification as well.
So I run a S5520HC board with RS2BL080 controller, I have the 4 and 6 drive hot swap bays.
My current configuration is 2x 600GB SAS (RAID 1) for my OS and 8x 300GB SAS (RAID 10) for whatever else.
I want to replace my 300GB SAS drives with higher capacity drives but will only do this if I can once again have a RAID 10 VD. How would I go about configuring this?
I would ideally like to install 8x 600GB SAS and if budget allows go for a 6x 800GB SSD.