Hello,
i have a ss4000-e running a raid10 on which one disk was about to fail.
Its led turned yellow, i rebooted the unit and after some hours it was fine again and the led was green.
Since it was some years running and last year i replaced another disk who failed, today i decided to
change all disks starting with that which recently failed.
So i replaced that disk ONLY and rebooted the unit.
Now, the worst is that it sees ALL disks as NEW !!..
And also putting the old disk in place of the new one, results in the "Disk changed" notify screen
on which all disks, although all serials numbers corresponds to the old disks and all are into their
correct slots (i replaced just one disk), are seen as NEW.
How can i bring my original configuration (and VERY hopefully) my datas back?
Many thanks for support.
Tom